"REPORT"

my collaboration in this project was the development of circuits, documents and building the prototype.

This team will work with a peaceful atmosphere and I was working with time and was arduous task for each team.

aprendizage acquired the shekel this school was very good because I was working with display, proportional control and programming on the Arduino.

"IP"

My contribution to the project was to help in the design and development of the prototype (Solar Oven) and also make circuits and assist in the preparation of the document.
I will work very well in the team, we work together and each contributes its opinion.
all expectations are met and that was achieved everything that had planned to advance this time and a little more. if you work as a team as before, it can reach the goal and meet all the requirements of the project.

"HW"

Bionic arm 90% cheaper than in the US

Bionic arm

Bionic Arm
Weight	2.06 Kg
Price Positioning Arm	$180,000.00
Price Hand Placement	$50,000.00
Accommodations	3
Tone Arm	5
Size	2

Getting people who have a disability in one of his arms or completely miss them, can have a better quality of life, rejoining best to a normal life.

"Troubleshooting" #5

"CONTRIBUTIONS"

My collaboration in the team was: to investigate everything related to electronics, protocol development (Goal, theoretical framework, justification), contribute ideas in the design and budget.
the team is working well grouped together.

"GLOSSARY"

Solar Energy

1. Spread irradiance is needed.

2. Yes, but they have the disadvantage.

3. No, because they need direct irrandiance.

4. The three.

5. In Germany.

6. Yes, but they have advantages and disadvantages.

7. Yes, it should be given much better and cheaper.

8. Yes.

9. Yes, because everyone will have much more opportunity to progress.

"Report"

Introduction

My collaboration on the computer was the elaboration of aim, some points of the Protocol, investigate points for each subject.

The project consists of the development of a Cartesian robot that has 3 degrees offreedom (X, Y, Z).

Report

My team is satisfied with the results of the Cartesian Robot because we all work with dedication in the project of the robot. We implement various activities in the project because we had to do all the physical part of the structure, because they are very important for the proper functioning of the CNC.

Conclusion
We are very pleased by the good teamwork that developed during the time we were working on the project.

We have new knowledge which are:
around management.
driving stepper motors.
Drivers management.

"INTEGRATION PROJECT"

My collaboration on the project was: paint the structure, etched rod, elaboration of circuits  etc.

What most us I complicated was adjust the rods.

Together with the team to be a worked very well.

"GLOSSARY"

"GLOSSARY"

"INTEGRATION PROJECT"

My collaboration on the computer was the elaboration of aim, some points of the Protocol, investigate points for each subject.

The project consists of the development of a Cartesian robot that has 3 degrees offreedom (X, Y, Z).

"COOLING SYSTEM"

1.- The pump pushes cold water through the tower.

2.- The cold water leaves the pipe.

3.- The hot air enters through the air inlet.

4.- The cold water cools the air.

5.- The cool air sinks to the bottom of the tower.

6.- The cool air enters the air vent.

7.- The cool air flows around the house.

8.- The cool air enters the chimney

9.- The sun heats the chimney.

10.- The hot air rises to the chimey.

11.- The hot air outs of through the air outlet.